How to Shingle a Valley

The do it yourself resource for homeowners from home improvement professionals.

How to Shingle a Valley

The valley on a roof is where two building wings meet or dormers protrude from the roof. The steps for how to shingle a valley are designed to create a completely water-resistant coating that sends water downhill. Under the roofing felt, flashing adds an extra layer of protection to the valley seam.

How to Shingle a ValleyTools You Need

A tool belt or tool bucket could be helpful when you’re up on the roof.

  • Ladder
  • Chalk line
  • 18” wide flashing
  • Tin snips
  • Shingles
  • 6-inch flexible broad knife
  • Rubber roller
  • Hammer
  • Utility knife
  • Marker

Directions for How to Shingle a Valley

  1. Snap chalk lines parallel with the valley 9 inches from its center on both sides.
  2. Bring enough 18-inch aluminum flashing up to the roof to cover the length of the valley.
  3. Line the flashing up with both chalk lines and press it into place down the seam of the valley.
  4. Use a rubber roller to press the flashing flush with the valley.
  5. Secure the flashing with roofing nails along its outer edges on both sides.
  6. Trim flashing with tin snips so that it lines up with the edges of the roof.
  7. Spread roofing tar with a flexible broad knife along both edges of the flashing.
  8. Snap two more chalk lines along the valley 18 inches from its center on both sides.
  9. Unroll roofing felt over the valley and trim it with a utility knife so that it lines up with the new chalk lines.
  10. Attach the felt with roofing nails but take care not to nail within 6 inches of the valley center.
  11. Lay a shingle over the valley so that one-third of it is on either side of the valley.
  12. Use a marker to draw lines on the outer edge of the shingle.
  13. Move the shingle aside.
  14. Create another chalk line based on the marker line to guide you when laying shingles.
  15. Snap more chalk lines 3 inches from the center of the valley.
  16. When nailing shingles do not drive any nails into the valley beyond this 3-inch border.
  17. Place your first shingle at the bottom roof edge with a 1/4-inch overhang.
  18. Cut the tabs off of this first shingle.
  19. Push the shingle down into the valley and nail it at the corners.
  20. Subsequent rows must overlap the previous rows by 6 inches.
  21. Add shingles until you reach the top of the roof valley.

Experienced New Jersey Roofers

When your roof is exposed, the elements have a greater possibility of damaging your property. Consider having the qualified team of skilled roofers at Bay Roofing replace your roof. Request an estimate from us today.